Simple Servo Controller Circuit

Schematic-


Parts List-
R1 - 1 - 820 Ohm 1/4W Resistor
R2 - 1 - 68K 1/4W Resistor
R3 - 1 - 10K 1/4W Resistor
R4 - 1 - 1K 1/4W Resistor
R5 - 1 - 1K Linear Taper Pot
C1 - 1 - 1uF 16V Electrolytic Capacitor
Q1 - 1 - 2N3904 NPN Transistor 2N2222, Most Small Signal Transistors
U1 - 1 - 555 Timer IC
MISC - 1 - Board, Wire, Knob For R1, 8 Pin Socket For U1

Notes-
1. R1 adjusts the position of the servo.

2. Connect the servo to the circuit as shown in the schematic. For common Futaba servos, the red wire is power, the black wire is ground, and the white wire is control.

1 comments:

how do the #1-8 connections to the 555 chip correspond to the actual input locations?

Post a Comment


Next.gr
Courtsy-simple-electronics.com

Share

Twitter Delicious Facebook Digg Stumbleupon Favorites More